Jump to content



Featured Articles

Check out the latest featured articles.

File Library

Check out the latest downloads available in the File Library.

New Article

Product Viscosity vs. Shear

Featured File

Vertical Tank Selection

New Blog Entry

Low Flow in Pipes- posted in Ankur's blog

Fired Heather: Pro Ii Simulation


This topic has been archived. This means that you cannot reply to this topic.
2 replies to this topic
Share this topic:
| More

#1 robalayon

robalayon

    Brand New Member

  • Members
  • 4 posts

Posted 13 April 2014 - 02:51 PM

Hi all, this a re-post:

I'm doing a project for the university, and it's about the desing of a fired heaters type box with a horizontal tube convection section. Well, I'm trying to simulate this on ProII, but i have a problem. Everytime that i run the process, software gives to me an error, and its say that "run is not available because Unit Operations are incomplete". I went to the "help" menu, but there could find any solution, or any specification about the simulation. 



#2 Zubair Exclaim

Zubair Exclaim

    Gold Member

  • Members
  • 123 posts

Posted 14 April 2014 - 02:57 AM

first of all .. dont use PROII use a fired heater design software such as FIHR or use HTRI or FRNC-5pc



#3 robalayon

robalayon

    Brand New Member

  • Members
  • 4 posts

Posted 15 April 2014 - 12:54 PM

Thanks. I'll do that. I was using ProII 'cause i didn't know which simulator use to do this. I know HYSYS is usefull, but i could find it in any place here on my country.






Similar Topics