Hi All,
I have an HC-30 Ventil control valve test bench and would like to know how I can test a class V control valve test at maximum differential pressure 220 KG/CM^2.
The procedure I used follows below;
1. Clamped the valve on my test bench taking into consideration FTO/FTC
2. open the valve
3.Pump water into the valve
4.Stroke the valve closed
5.Try to achieve 220 KG/CM^2 but was unsuccessful due to limitations in the pump as the pressure was not maintaining...i.e constant.
Can you advise of any other method which I can test such?
Appreciate your feedback.
Thanks,
Naresh