Jump to content



Featured Articles

Check out the latest featured articles.

File Library

Check out the latest downloads available in the File Library.

New Article

Product Viscosity vs. Shear

Featured File

Vertical Tank Selection

New Blog Entry

Low Flow in Pipes- posted in Ankur's blog

Cpf Feed Composition Condition


This topic has been archived. This means that you cannot reply to this topic.
3 replies to this topic
Share this topic:
| More

#1 mguezguez

mguezguez

    Brand New Member

  • Members
  • 3 posts

Posted 29 August 2015 - 03:59 AM

Good morning everybody.

 

I want to ask a question about the conditions of a multiphase composition.

 

Given the composition of the well stream, should i start with a feed comosition at standard conditions (15.00 °C and 101.325 kPa) to feed a 3 phase separator in order to define the oil, gas composition and flowrate then use these streams at first stage pressure and temperature condition to mixture them before the first stage separator.

 

Best Regards



#2 Bobby Strain

Bobby Strain

    Gold Member

  • Members
  • 3,529 posts

Posted 29 August 2015 - 09:00 AM

All that work is unnecessary. I presume that you have a process simulator.

 

Bobby



#3 mguezguez

mguezguez

    Brand New Member

  • Members
  • 3 posts

Posted 31 August 2015 - 04:17 AM

Thank you for your response,

 

In fact i worked with Hysys simulator but i hesitate about the 3 phase separator feed composition conditions.



#4 mguezguez

mguezguez

    Brand New Member

  • Members
  • 3 posts

Posted 31 August 2015 - 08:21 AM

To explain more, I have the oil flow, gas and water flowrate and the well fluid molar composition.
I have also the operating conditions of the first three-phase separator.
To start the Hysys simulation, my question is about the conditions taken for determination of the composition.
The composition is water-free so I have to redo the oil-gas-water mixture.





Similar Topics