Jump to content

  2. →
  3. →


Featured Articles

Check out the latest featured articles.

File Library

Check out the latest downloads available in the File Library.

New Article

Product Viscosity vs. Shear

Featured File

Vertical Tank Selection

New Blog Entry

Low Flow in Pipes- posted in Ankur's blog

0

Aspen Dynamic

Started by Behzad_1981, Mar 05 2021 04:47 AM

4 replies to this topic
Share this topic:
| More

#1 Behzad_1981

Behzad_1981

    Brand New Member

  • Members
  • 3 posts

Posted 05 March 2021 - 04:47 AM

Hello everyone,
 
I need your assistance for the preparation of dimethyl ether. 
I have simulated the whole thing and it has converged. But for exporting to the dynmic simulation the pressure check is pressed.  Then I get a message like this.
 
 
Warning for inlet pressure drops:
The inlet stream pressure is not equal to the block pressure in the following blocks:
 
B11
B15 stage 15
B17 stage 18
 
For dynamic simulation, the inlet pressure change will be fixed to the steady state value. If you want the inlet pressure drop to vary with flowrate, change your simulation to use a Valve to model the inlet pressure drop.
 
 
Pressure Check completed with Warnings.

Attached Files


Edited by Behzad_1981, 05 March 2021 - 06:09 AM.

#2 pmoneysh

pmoneysh

    Veteran Member

  • Members
  • 31 posts

Posted 07 March 2021 - 08:14 PM

you can manually change the inlet pressure equal to the stage pressure. Or you can export this file to dynamic mode since this is not an error but a warning which is fixed by aspen itself when exported.


#3 Behzad_1981

Behzad_1981

    Brand New Member

  • Members
  • 3 posts

Posted 08 March 2021 - 07:10 AM

Thank you for the answer, that is correct I have set the feed pressure equal to the stage pressure and the error is solved, but in another simulation it does not work so, I have reduced the weir height according to William Luyben, and still the error is there.

#4 pmoneysh

pmoneysh

    Veteran Member

  • Members
  • 31 posts

Posted 08 March 2021 - 11:15 PM   Best Answer

Increase the  pressure drop along the column. There might not be enough driving force.


Edited by pmoneysh, 08 March 2021 - 11:18 PM.

#5 Behzad_1981

Behzad_1981

    Brand New Member

  • Members
  • 3 posts

Posted 22 March 2021 - 05:46 AM

Thank you  :)


Back to Chemical Process Simulation

Similar Topics




  1. Cheresources.com Community
  2. → Chemical Process Simulation
  3. → Chemical Process Simulation
  4. Guidelines / Rules for Posting