Hi
I would like to find out if there are any pumps in the industry catered for small increases in pressure (~2.5 psi)?
My fluid flow rate is 77 gpm.
Thank you.
Best regards,
Sharon Lam
|
Posted 03 April 2019 - 03:26 AM
Hi
I would like to find out if there are any pumps in the industry catered for small increases in pressure (~2.5 psi)?
My fluid flow rate is 77 gpm.
Thank you.
Best regards,
Sharon Lam
Posted 03 April 2019 - 03:43 AM
Hi
I would like to find out if there are any pumps in the industry catered for small increases in pressure (~2.5 psi)?
My fluid flow rate is 77 gpm.
Thank you.
Best regards,
Sharon Lam
Dear Sharon, pump will work based on system pressure. i don't see any issue to get the pump. if you talk to pump vendor regarding to your requirement, they will give any pump that can give more then your requirement (flow and head). and when it come to actual (during operating), pump discharge pressure will be lower then your expectation as pump discharge pressure will be based on your actual discharge system pressure.
Posted 03 April 2019 - 07:00 AM
Hello,
What is the pump discharge pressure and flow rate?
The question you are asking is not clear for me, could you please elaborate?
Thanks
Raman
Posted 03 April 2019 - 07:41 AM
I think a small canned pump could reach this flow and pressure
Edited by thorium90, 03 April 2019 - 07:41 AM.
Posted 03 April 2019 - 08:13 AM
Dear Sharon,
your request is very vague...but, I'm incidentally working on little pumps and I'd like to share with you the attached pump selection graph.
A pump of the BT-500 series could serve your scope....
Just to prevent comments, the 60 Hz series is also available ;-)
good luck!
Edited by gegio1960, 03 April 2019 - 08:17 AM.
Sizing Of Vertical/horizontal Flash DrumStarted by Guest_Mohammad3799_* , 10 Mar 2024 |
|
|
||
Piping Design_ Pump PipelineStarted by Guest_anh.phungthai@boydensvn_* , 29 Feb 2024 |
|
|
||
Design Criteria For Sizing Sump Drum Of Close Drain System In Tank FarStarted by Guest_AnbIran_* , 28 Feb 2024 |
|
|
||
Ro SizingStarted by Guest_T_bag_* , 27 Feb 2024 |
|
|
||
Vent Sizing Using GooseneckStarted by Guest_mychemicalromance0425_* , 23 Feb 2024 |
|
|