No replies to this topic

[solidheart]

Dear all,
Hp u all ok and doing well and i wish u accept me between as a new student to this great and useful forum. Indeed, it is my first tiime to write in here and i am afraid it is asking for help from the professionals in here like u all

the matter is that, i have to do a simulation for any centrifugal pump to show where the cavitiation problem could happen in the suction pipe and in the impeller in solidworks... so would you please help me and send any information that can help me drawing it in solidworks and then to run the analysis on it. in fact i am new in using the solidworks but i have successfully built up a four stroke engine using the solidworks.... i am so thankful to u all for ur help
kind regards