|

Pump Selection For Condensate Or Liquid With High Vapour Pressure
Started by taufiq akbar, Dec 20 2013 05:31 AM
oil transfer pump
4 replies to this topic
Share this topic:
#1
Posted 20 December 2013 - 05:31 AM
Please give me recommendation about pump selection.
i want to pumping oil with properties and composition similar condensate fluid with vapour pressure 12.9 psia.
Result of my calculatio with arrangment pipe existing, npsha 1.474 meters exclude margin 1 meter.
please give me recommendation when i will choose pump with capacity 60 m3/hr and head 660 ft.
Thanks,
Akbar
i want to pumping oil with properties and composition similar condensate fluid with vapour pressure 12.9 psia.
Result of my calculatio with arrangment pipe existing, npsha 1.474 meters exclude margin 1 meter.
please give me recommendation when i will choose pump with capacity 60 m3/hr and head 660 ft.
Thanks,
Akbar
#2
Posted 20 December 2013 - 05:42 AM
Akbar,
Appears you need a low NPSHR pump. Then, fill the relevant data sheet and send it to a reputable vedor to propose his selection...
#3
Posted 20 December 2013 - 05:57 AM
Fallah,
thanks for your replies.
Some vendor give me any quotation and technical proposal for using vertical inline OH3,
what are there type pump with npshr lower than vertical inline OH3.
if any recommendation, please share to me.
one else, material selection for pump with properties chlorine more than 3000 ppm.
how many minimum composition when we use duplex?
thanks for your replies.
Some vendor give me any quotation and technical proposal for using vertical inline OH3,
what are there type pump with npshr lower than vertical inline OH3.
if any recommendation, please share to me.
one else, material selection for pump with properties chlorine more than 3000 ppm.
how many minimum composition when we use duplex?
#4
Posted 20 December 2013 - 06:42 AM
Akbar,
About the pump type vendor can propose the best one, but for chlorine content more than 3000 ppm duplex or superduplex grades would be suitable for the pump material...
#5
Posted 22 December 2013 - 01:29 PM
Vertical inline pumps have the minimum NPSH requirement. I have seen numerous designs from pump vendors and all of them recommended vertical inline design when we needed lower NPSHR.
Similar Topics
Steam Pressure In Heat ExchangerStarted by Guest_mvanrijnbach_* , 15 Apr 2025 |
|
![]() |
||
Selection Type Of Heater For Refrigerated PropaneStarted by Guest_livetolove003_* , 07 May 2025 |
|
![]() |
||
![]() Liquid Liquid Separator SizingStarted by Guest_Kentucky08_* , 03 Apr 2025 |
|
![]() |
||
Thermal Oil Pump Motors Blew OffStarted by Guest_lizelle_* , 02 May 2025 |
|
![]() |
||
Critical Pressure For Choke Valve SizingStarted by Guest_Sherif Morsi_* , 07 Nov 2017 |
|
![]() |