3 replies to this topic

[Yasserkassem]

calculation of :

 

8- Liquid and gas retention time in separators

 

9- sizing of 2 phase separator with examples

 

10- design of 3 phase separators with examples

 

11- Heat Required for heating crude oil

 

12- Salt Content in crude oil

 

13- Gas Orifice and gas rate Calculations

 

14- Liquid Measurements with orifice

 

15- Control Valve Sizing for gas and liquids

 

 8- Liquid and gas retention time in separators.docx   18.06KB   40 downloads

 9- sizing of 2 phase separator with examples.docx   768.24KB   50 downloads

 10- design of 3 phase separators with examples.docx   333.24KB   45 downloads

 11- Heat Required for heating crude oil.docx   15.53KB   28 downloads

 12- Salt Content in crude oil.docx   14.53KB   28 downloads

 13- Gas Orifice and gas rate Calculations.docx   68.77KB   32 downloads

 14- Liquid Measurements with orifice.docx   149.05KB   28 downloads

 15- Control Valve Sizing for gas and liquids.docx   473.43KB   45 downloads

 

 

 

 

 

Main Site

https://oilprocessing.net/

Edited by Yasserkassem, 10 March 2021 - 03:35 AM.

[Divid Kelin]

Excellent job dear
Keep it up

[adhinaharindra]

great and very helpful tools

thx

[Bobby Strain]

There are always risks in using  software or procedures that are not vetted. I recommend that no one should use them for real work without thorough validation. That applies to my work, too. This applies equally well to spreadsheets and procedures from sources like GPSA. And some textbooks from well know professors. Spreadsheets are notoriously risky. But there are some reliable sources. Most risky are spreadsheets that rely on cell formulas. And/or "poke & hope" solution technique.

 

Bobby

Edited by Bobby Strain, 27 December 2021 - 11:39 PM.