Jump to content



Featured Articles

Check out the latest featured articles.

File Library

Check out the latest downloads available in the File Library.

New Article

Product Viscosity vs. Shear

Featured File

Vertical Tank Selection

New Blog Entry

Low Flow in Pipes- posted in Ankur's blog

1

Display Problem Of Stripchart In Hysys Dynamic Simulation

stripchart hysys

3 replies to this topic
Share this topic:
| More

#1 imeagor

imeagor

    Brand New Member

  • Members
  • 6 posts

Posted 13 April 2019 - 03:13 PM

hello everyone,

Recently I have met with a problem about stripchart display in hysys dynamic simulation. During the running case, I can see the curve in the stripchart window. However, when the running stops, the time axis range was changed to full range(from zero time) through the graph control menu, only the last 100min there was curve(before this point is blank). please see the attached pic.

Attached File  剪贴板-1.jpg   56.25KB   2 downloads

 

Please who have experience give some information how to make the stripchart display in the full range.

Thanks in advance.



#2 M-Engineer

M-Engineer

    Brand New Member

  • Members
  • 6 posts

Posted 22 April 2019 - 07:49 AM

Hello imeagor,

 

You can simply move the red triangle on the lower left corner (low time axis control) to the right to adjust the required view.



#3 imeagor

imeagor

    Brand New Member

  • Members
  • 6 posts

Posted 23 April 2019 - 04:43 AM

Thank M-Engineer's reply.

As you said, if the display is not the full range, we can use red triangles to adjust the range, but now the display is full range (0-265min).

The problem is that there is no curve in 0-160min range. I don't know why.



#4 M-Engineer

M-Engineer

    Brand New Member

  • Members
  • 6 posts

Posted 05 May 2019 - 04:14 AM

Hello imeagor,

 

One reason for this "There are no results for the period from 0-160 min" is that the parameters are added to the stripchart at the solving time of 160 min.

 

You can solve this by resetting the integrator time to zero then running the model again.

 

Sorry for the late reply.

 






Similar Topics