|
|
Zinc Mass Filtration Issue
#1
Posted 27 September 2019 - 12:09 PM
We have encountered zinc acetate filtration issue in pilot plant.
Mass contains water+acetic acid+product+zinc chloride
Mass was very viscous.
We used leaf filter to filter the mass.
Initially we pumped the mass to leaf filter, from leaf filter mass is not coming and chocked inside leaffilter.
Pls suggest best filter ways
Looking for valuable suggestions
#2
Posted Today, 01:46 AM
With a very viscous zinc acetate / zinc chloride mass, a leaf filter will choke quickly if the solids are fine, compressible, or if the mass cools and thickens further on the cloth, so I would first check the viscosity and solids character before changing the filter itself.
Measure viscosity versus temperature, solids content, particle size and whether the solids are crystalline or gel-like. Heating the feed and the filter, and keeping the lines and leaf warm, often makes a large difference, because a modest temperature rise can cut viscosity sharply and keep zinc salts in solution instead of crystallising on the media. Do not let the mass sit and cool in the filter.
For the filtration step itself, try a precoat and body feed of filter aid on a coarser cloth first, at low differential pressure, and increase pressure only gradually. A fine cloth with high initial pressure will blind immediately with compressible solids. A small laboratory pressure filtration test at constant pressure will tell you the cake resistance and whether the cake is compressible, and that data is much more reliable than trial and error on the leaf filter.
Also check the feed pump and piping. A centrifugal pump can shear and recirculate the mass, while a low-shear positive displacement feed at a controlled rate gives a more even cake. Make sure the leaf is fully vented, the feed is distributed evenly, and the discharge side is not restricted.
If the cake remains very thin, slimy or impermeable even with filter aid and heat, a leaf filter may simply be the wrong choice for this duty. A pressure Nutsche filter, a candle filter with precoat, or a centrifuge is often better for viscous, fine or compressible solids, followed by washing the cake with a compatible warm solvent to remove mother liquor and soluble zinc chloride. What temperature, solids loading and particle size are you working with, and how thick is the cake when it stops flowing?
Edited by AsherMuse, Today, 01:46 AM.
Similar Topics
Approach To Calculate The Overall Mass Transfer Coefficient In A RecirStarted by Guest_Basticcas_* , 17 Nov 2026 |
|
|
||
How To Estimate The Water Dewpoint From Heat And Mass Balance Of NaturStarted by Guest_krishnnaa26_* , 30 Apr 2026 |
|
|
||
Spray Dryer Nozzle Issue – Pressure Increase And Fines IncreaseStarted by Guest_Ella2365_* , 24 Mar 2026 |
|
|
||
Aspen Plus Rcstr Convergence Issue – Mass Balance Error In Anaerobic DStarted by Guest_Marie26_* , 05 Apr 2026 |
|
|
||
Organic Peroxide Distillation IssueStarted by Guest_Kimbreaux_* , 19 Feb 2026 |
|
|

FB





