3 replies to this topic

[tokotof]

I checkde with GPSA and Bryan Research and Engineering to model an amine sweetening process using Amdea (MDEA 45wt + PZ 5wt).

Instead of a trial-and-error approach, I am looking for an equation or method to preliminarily estimate the circulation rate before the detailed design phase.
 

I have seen preliminary circulation rate guidelines for MEA, MDEA, and DEA etc, in various references.

However, I am unsure how to approach this for Amdea.

Does anyone know how to estimate the preliminary circulation rate for this specific blend or have any references or methodologies for this?

Is the only way to estimate the flow rate just to input it into HYSYS and check the results?


If you could recommend any literature or articles, I would deeply appreciate it and read them thoroughly! I've been searching for this issue for a month now!
 

 

[Pilesar]

Circulation rate is calculated from the rich and lean compositions and the gas treatment requirements. This is just a material balance problem. Are you struggling with knowing the rich and lean compositions? Or the volume flow of gas? Or the composition of the inlet and outlet gas? The amine flow rate is the only unknown variable after these inputs are known.

[tokotof]

L_s = G_s*(Y_N+1-Y₁)/(X_N-X₀)

Thanks to you i use this equation. whichi is

 

Gas Flowrate on Solute Free Basis [G_s]

 

 

+10%

-10%

ⓘ Solute Free Mole Fraction of Gas in Inlet [Y_N+1]

 

 

+10%

-10%

ⓘ Solute Free Mole Fraction of Gas in Outlet [Y₁]

 

 

+10%

-10%

ⓘ Solute Free Mole Fraction of Liquid in Outlet [X_N]

 

 

+10%

-10%

ⓘ Solute Free Mole Fraction of Liquid in Inlet [X₀]

Thank you for your kind response. I am currently designing the process as follows. What I am struggling with is determining the appropriate values for ⓘ Solute Free Mole Fraction of Liquid in Outlet [XN] and Solute Free Mole Fraction of Liquid in Inlet [X0]. Is there a standard or guideline for these values? please  recomend any documents and books.. thanks



 

 

Circulation rate is calculated from the rich and lean compositions and the gas treatment requirements. This is just a material balance problem. Are you struggling with knowing the rich and lean compositions? Or the volume flow of gas? Or the composition of the inlet and outlet gas? The amine flow rate is the only unknown variable after these inputs are known.

 

 

귀하의 안내 덕분에 현재 다음과 같이 프로세스를 설계하고 있습니다.

 

Edited by tokotof, 02 December 2024 - 06:04 PM.

[breizh]

Hi,

If I was in your shoes, I would try to find supplier of this chemicals on Internet. Then I will email or ring them to get data /brochures about the system AMDEA / gas to be treated. It's in their interest to share data to promote their solvent.

https://www.aidic.it...a/420etoumi.pdf

 

https://onepetro.org...DEA +piperazine

 

Part 1 – Estimation of Solubilities of Selected Hydrocarbon Compounds in Treating Solvents | Campbell Tip of the Month

 

Good luck

Breizh