Jump to content

Featured Articles

Check out the latest featured articles.

File Library

Check out the latest downloads available in the File Library.

New Article

Product Viscosity vs. Shear

Featured File

Vertical Tank Selection

New Blog Entry

Low Flow in Pipes- posted in Ankur's blog

Aspen Pims Group

This topic has been archived. This means that you cannot reply to this topic.
1 reply to this topic
Share this topic:
| More

#1 Alawi


    Veteran Member

  • Members
  • 41 posts

Posted 26 April 2007 - 02:31 AM

Hello every one,

I am hopping to exchange knowledge with users of Aspen PIMS, I am a chemical engineer working in crude oil refinery. I will try my best to answer all questions I receive (regarding Aspen PIMS or/and any other subject related to chemical engineering).
My new topic is about using two measuring basis in the same module, i.e. using both mass and volume units in the module. This is suggested due to the fact that our sales differ in measuring units according to the product itself, we sell gasoline and diesel in Liters but asphalt and fuel oil in tons. Incase any one has experience in constructing a two basis (volume and mass) module or any other comments and suggestions I would be more than welling to hear.
Although replies are preferred to be within the forum to generalize the benefit of any such discussion my personal email address for detailed technical issues is as follows: thaher11@yahoo.com

Kind regards



  • guestGuests
  • 0 posts

Posted 12 June 2008 - 03:23 AM

Dear Alawi,
i am also study on this software. Very glad to exchange with you some problems with PIMS

Similar Topics