|
0
Dynamic Simulation
Started by halamcongtu, May 04 2018 01:42 PM
2 replies to this topic
Share this topic:
#1
Posted 04 May 2018 - 01:42 PM
I have a project in which my feed is pumped through some heat exchangers and then go into the column.But when I switch to dynamic, feed rate value was smaller than steady state value, about 5% or less.
#2
Posted 04 May 2018 - 03:12 PM
Put a flow control loop in your dynamic simulation to get the flow you want.
#3
Posted 06 May 2018 - 11:10 PM
Put a flow control loop in your dynamic simulation to get the flow you want.
Agree.. I was once struggling with the flow when I firstly turned the simulation into dynamic mode. But when I put the flow control loop in the stream, I can get the flow as I wanted.
Similar Topics
Ammonium Sulfate Process SimulationStarted by Guest_amir55261_* , 06 Apr 2024 |
|
|
||
Olga And Aspen Simulation SoftwareStarted by Guest_CHEMSTRONG_* , 27 Mar 2024 |
|
|
||
Aspen Hysys SimulationStarted by Guest_amazingspidermean_* , 18 Mar 2024 |
|
|
||
Linear Alkyl Benzene Sulfonic Acid Production (Labsa) SimulationStarted by Guest_Emranm02_* , 03 Mar 2024 |
|
|
||
Stabilizer SimulationStarted by Guest_prashant.badgujar_* , 02 Feb 2024 |
|
|