Pipe spec where we need to specify... I have attached file, there are three cases which one is correct to show pipe spec.
Basically it is Fuel gas connection to flare header.
|
Posted 30 December 2015 - 10:36 PM
Pipe spec where we need to specify... I have attached file, there are three cases which one is correct to show pipe spec.
Basically it is Fuel gas connection to flare header.
Posted 31 December 2015 - 02:51 AM
For me, as long as it is understandable where the needed spec break location it should be ok regardless of how it represent in the P&ID. It just a cosmetic issue. The main thing is make sure it is at correct location i.e. if the spec break is downstream of the valve, don’t put it at the upstream of the valve.
Kindly refer hand sketch for my previous practice.
Posted 31 December 2015 - 03:54 AM
what it means I couldn't understand farid.k ""if the spec break is downstream of the valve, don't put it at the upstream of the valve"
Posted 02 January 2016 - 07:47 PM
what it means I couldn't understand farid.k ""if the spec break is downstream of the valve, don't put it at the upstream of the valve"
dear shiva,
"Spec break" happens where there is a change from one significant design condition to another.
For example, at up stream of the PSV there is a design condition with a higher pressure that requiring a higher pipe spec i.e. 300# rating pipe spec. Down stream of the PSV there is a flare collection system (or atmosphere) with a much lower design condition which is not necessary to use 300# rating. Thus it is more reliable & economical to use 150#. Therefore there would be a "spec break" at the downstream side of the PSV.
hope this help
Higher Pipe Line Dia Specification In UnisimStarted by Guest_Praveen Perumandla_* , 27 Feb 2024 |
|
|
||
Sizing Of Cooling Water Pipe LineStarted by Guest_Asif Azeez_* , 08 Jan 2021 |
|
|
||
Gas In Pipe SupportStarted by Guest_Stellaandoor_* , 26 Jan 2024 |
|
|
||
Recommended Velocity For Highly Viscous Liquid In A PipeStarted by Guest_Quimarah_* , 13 Oct 2023 |
|
|
||
Hysys Pipe Segment For Two Phase LineStarted by Guest_tdeb_* , 15 Jun 2023 |
|
|