34 replies to this topic

[jetul]

Profe,

I need these articles. Kindly send it at:
jetul@rediffmail.com

Regards,
Jetul.

[Profe]

Hi all who interested in this subject.

Attached you will find two articles for distributors

Good luck.

Attached Files

•  Design gas distributors.pdf   1.02MB   162 downloads
•  Pipe and ring spargers.pdf   556.77KB   179 downloads

[ALEXV]

Dear Profe,

Could you please send me a copy of steam sparger article too?

Thanks

[SubbuVenkat]

Hi Profe,

Could you send me a copy as well?

subbuvenkat10@gmail.com

[Profe]

Hi SubbuVenkat
About your request, please review two post before (the number 27) and you can download the pdf articles.

Good luck.

[S.AHMAD]

Shiva
1. The critical design parameter is to limit the velocity of crude for each slot of not more than 1 m/s. (3 ft/s).
2. From the flowrate, determine the total number of slots required to meet the velocity limit. Typical length of slot is 12" and the slot width may range from 4" to 8" depending on the total flowrate.
3. Do trial and error to determine the total length of distributor that meet the tank diameter and the velocity criteria.
4. Unable to provide more details (drawings) due to proprietary nature of the information but use you creativity in the design.
5. I suggest that you prepare the proposed sketch (drawing) based on your creativity for further comments and suggestion for further improvement since I have a typical figure of the distributor.

Edited by S.AHMAD, 04 December 2012 - 09:25 PM.

[Rodscott]

Hi Profe,
Could I please also get a copy of this article. Much appreciated.

rodscott2@yahoo.com.br

Thanks in advance!

Rodscott

Profe,
please send me the article at webmaster@chem24h.com ,Thanks!

[Raj Sardhara]

Hi Profe,

Could you send me a copy as well?

 

raju_sardhara@atul.co.in

 

Thanks,

 

Raj

[punam06]

kindly send the article of gas distributor at punamchem06@gmail.com