Jump to content

Featured Articles

Check out the latest featured articles.

File Library

Check out the latest downloads available in the File Library.

New Article

Product Viscosity vs. Shear

Featured File

Vertical Tank Selection

New Blog Entry

Low Flow in Pipes- posted in Ankur's blog


Lng Heat Exchanger

lng unisim design

2 replies to this topic
Share this topic:
| More



    Junior Member

  • Members
  • 11 posts

Posted 14 September 2018 - 01:28 AM


I'm trying to simulate lng heat exchanger in UniSim design. I have not enough data for dynamic simulation so I tried to calculate it in steady state. I have temperatures for all streams (there are one hot stream and two cold ones). But I don't know UA. Is it possible to take data from steady state to dynamic mode using only geometric sizes and stream temperatures?

Thank you

#2 Bobby Strain

Bobby Strain

    Gold Member

  • Members
  • 2,901 posts

Posted 14 September 2018 - 09:04 AM   Best Answer

UniSim will calculate UA values from your steady state simulation. You can use the values in dynamic mode.





    Junior Member

  • Members
  • 11 posts

Posted 15 September 2018 - 03:26 AM

Got it. Thank you very much

Edited by ELVINA, 15 September 2018 - 03:53 AM.

Similar Topics